TM 9-2320-280-34
15-4. 9,000 LB. ELECTRIC WINCH REPAIR (Cont'd)
10.
Mark motor end drum support (2) and gear end drum support (4) for assembly.
11.
Remove six capscrews (5) and three tie rods (6) from motor end drum support (2) and gear end drum
support (4).
12.
Place winch on end with motor end up and remove two hex head screws (1) and motor (10) from motor end
drum support (2).
13.
Remove gasket (9) and motor end drum support (2) from drum assembly (3). Discard gasket (9).
14.
Remove motor shaft coupling (8) and input shaft (7) from drum assembly (3).
15.
Remove drum assembly (3) from gear end drum support (4).
16.
Remove two nylon thrust washers (11) from drum assembly (3).
17.
Push brake (13) through open end of drum assembly (3) and remove thrust washer (12).
18.
Remove drive shaft (15) from gear housing (17).
19.
Turn gear housing (17) over with gear end drum support (4) down and remove ten hex head
screws (18) and gear housing (17) from output ring gear (16).
20.
Remove gasket (14) from output ring gear (16). Discard gasket (14).
Change 2
