TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY
AND GEAR UNIT, AND REAR BAND MAINTENANCE (Cont).
Install sun gear shaft (19) with larger, splined end down,
Lubricate pinion gears (43) in reaction carrier (21) with hydraulic fluid and install reaction
carrier on output carrier (22) so that pinion gears mesh with front internal gear.
Lightly coat 2 races (33 and 35) and
thrust bearing (34) with petrolatum,
Install large diameter race (33) on
sun gear shaft (19) with flange facing
up. Install thrust bearing on race
(33). Install small diameter race (35)
on sun gear shaft with flange facing
Install any roller that may have come
out of roller clutch assembly (20)
cage by compressing energizing
spring with forefinger and installing
roller from outer side, If any rollers
are missing, replace roller clutch
Install roller clutch assembly (20) in
reaction carrier (21).
(See paragraph 5-17,
ASSEMBLY, step 13)
Lightly coat thrust washer (23) with
petrolatum and install in recess of
center support assembly (8).