f . I N S T A L L A T I O N

5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Cont) - TM-9-2320-289-34_486

5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Cont) - TM-9-2320-289-34_488

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
470

TM 9-2320-289-34 5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Con’t). NOTE Ensure that center support-to- reaction carrier thrust washer is still in place before installing center support assembly (8) into roller clutch in reaction carrier (21). 27. Install center support assembly (8) into roller clutch (20) in reaction carrier (21 ) using a counterclockwise motion. Hold reaction carrier and attempt to turn center support assembly in both directions. Center support assembly should turn counterclockwise only. If center support assembly turns clockwise, disassemble to determine problem. f . I N S T A L L A T I O N NOTE Rear band (18) should be soaked in hydraulic fluid a minimum of 15 minutes. 1. Install rear band (18) in transmission case (5) so that band lugs line up with anchor pins. TA50305 5-126

Privacy Statement
Press Release
Contact