5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Cont)

5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Cont) - TM-9-2320-289-34_488

5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Cont) - TM-9-2320-289-34_490

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
472

TM 9-2320-289-34 5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Con’t). 5. Lightly coat thrust washer (15) with petrolatum and install to rear face of output shaft (13) with bent tabs in tab pockets. NOTE An over tightened transmission holding fixture side pivot bolt will cause binding when center support and gear unit assembly (14) is installed. 6. Loosen transmission holding fixture side pivot bolt so that it does not put pressure against transmission case (5) . CAUTION Be careful to not drop or bump center support and gear unit assembly (14) during installation. Failure to follow this caution may result In damage to output shaft (13) bushing in transmission case (5) or to assembly itself. NOTE it may be necessary to maintain allnement of rear band through access hole in transmission case (5) to prevent binding when installing center support and gear unit assembly (14). 7 . Cover output shaft (13) with duct tape to prevent spline damage. With transmission case (5) in a vertical position, install center support and gear unit assembly (14), by lining up slots and carefully guiding center support and gear unit assembly into transmission case. Ensure that center support bolt hole is properly alined with hole in transmission case. 8 . Remove gear holding unit and duct tape from output shaft (13). TA50307 5-128

Privacy Statement
Press Release
Contact