TM 9-2320-289-34
5-19.
TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY
AND GEAR UNIT, AND REAR BAND MAINTENANCE (Con’t).
12.
13.
l
l
NOTE
Intermediate clutch wave plates (3) should be soaked in hydraulic fluid
approximately 15 minutes.
Clutch wave plate (4) has 2 “V” marks cut in outer circumference,
Turn transmission case (5) to a vertical position. Lubricate intermediate clutch plates with
hydraulic fluid, Install clutch wave plate (4). Install 3 intermediate clutch wave plates (3) and 2
flat steel clutch plates (6). Install an intermediate clutch wave plate first and alternate with a
flat steel clutch plate. Install intermediate clutch backing plate (2) with flat machined surface
against clutch plates.
Install snapring (1) with snapring gap on side of transmission case (5) opposite front band
anchor pin.
FOLLOW-ON TASKS:
• Check rear unit end play. (See paragraph 5-18)
l Install governor assembly. (See paragraph 5-5)
TA50309
5-130
