5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Cont)

5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Cont) - TM-9-2320-289-34_483

5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Cont) - TM-9-2320-289-34_485

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
467

TM 9-2320-289-34 5-19. TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY AND GEAR UNIT, AND REAR BAND MAINTENANCE (Con’t). 11. 12. 13. Install rear internal gear (42) on end of mainshaft (12) that has snapring groove. Install snapring (44). Lightly coat races (45 and 47) and thrust bearing (46) with petrolatum, Install large diameter race (47) on mainshaft (12) first, with flange facing up. Install thrust bearing in race (47), Install small diameter race (45) on thrust bearing with inner flange facing down. Lubricate pinion gears (43) in output carrier (22) with hydraulic fluid and install output carrier on mainshaft (12) so that pinion gears mesh with rear internal gear (42) and rotate freely. Place assembly in a soft-jawed vise with mainshaft pointing downward. 14. Lightly coat races (39 and 41) and thrust bearing (40) with petrolatum. Install small diameter race (41 ) to outer face of rear internal gear (42) with flange facing up, Install thrust bearing in race (41). Install large diameter race (39) with flange cupped over thrust bearing. 5-123

Privacy Statement
Press Release
Contact