TM 9-2320-289-34
5-19.
TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY
AND GEAR UNIT, AND REAR BAND MAINTENANCE (Con’t).
9 .
Lubricate snapring (9) with hydraulic
fluid and install with beveled side up,
flat side against center support
assembly (8). Position snapring so
that its gap alines with front band
anchor pin (10). Expand snapring
until center support assembly is
against shoulder of transmission case
(5) .
10.
Turn transmission case (5) to a
horizontal position with case valve
body mounting face (57) up.
CAUTION
When using tool (56), be careful
to not raise burrs on case valve
body mounting face (57).
11. Place a suitable tool (56) into the
direct clutch passage in transmission
case (5). Apply pressure downward
on tool and hold center support
assembly
(8)
firmly
counter-
clockwise against the transmission
case spline. Using a 3/8 in. 12-point
thin wall deep socket (7), install
center support assembly bolt and
tighten to 25 Ib. -ft. (34 N.m).
5-129
