TM 9-2320-289-34
5-19.
TRANSMISSION INTERMEDIATE CLUTCH, CENTER SUPPORT ASSEMBLY
AND GEAR UNIT, AND REAR BAND MAINTENANCE (Con’t).
NOTE
2.
3.
Spacer (16) is thinner than other 2
remaining snaprings, It measures
0.040 in. (1.016 mm) and both
sides are flat.
Inspect spacer (16) for burrs or
raised edges, If present, remove with
crocus cloth. Install spacer against
shoulder at bottom of transmission
case (5) splines.
Lightly coat selective washer (17)
with petrolatum.
Install selective
washer into slots provided in rear of
transmission case (5).
4.
Install gear holding unit (11) on end of
mainshaft (12) so that tangs engage
groove on shaft. Tighten screw on
gear holding unit to secure it t o
center
support
and
gear
unit
assembly (14) and to prevent
movement of the roller clutch during
installation, Remove assembly from
vise and lay on its side,
TA50306
5-127
