4-10. ENGINE WIRING HARNESS REPLACEMENT (Cont)

4-10. ENGINE WIRING HARNESS REPLACEMENT (Cont).

4-10. ENGINE WIRING HARNESS REPLACEMENT (Cont) - TM-9-2320-289-34_341

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
323

TM 9-2320-289-34 4-10. ENGINE WIRING HARNESS REPLACEMENT (Con’t). NOTE M1010 trucks with retrofit wiring will have additional wiring from engine wiring harness block (38) to current/voltage regulator. 5 . Secure retrofit wiring to engine wiring harness with 6 new tie-down straps. 6. Connect leads to glow plug relay (40), and install 2 new starwashers and 4 nuts. Connect leads to engine wiring harness block (38), and install large nut (39) and small nut (37). 7. Connect windshield wiper motor assembly capacitor connector (43). Connect leads to windshield wiper motor (41 ), Install pink sending unit lead into terminal “30” on fuse box, Connect engine wiring harness to rear of fuse box (42) and tighten bolt (44), TA50844 4 - 7 8

Privacy Statement
Press Release
Contact