TM 9-2320-289-34
4-10.
ENGINE WIRING HARNESS REPLACEMENT (Con’t).
10.
11.
12.
1 3 .
Remove bolt and Iockwasher from clip (34), and disconnect lead from compressor (33).
Discard Iockwasher.
Disconnect water temperature connector (46) and 4 left side glow plug connectors (45).
Disconnect glow plug wiring harness (36), Disconnect oil pressure sending unit connector (35)
located behind glow plug wiring harness connector.
Loosen bolt (44) and disconnect engine wiring harness from rear of fuse box (42). Depress
sides of terminal “30” on fuse box, and disconnect pink sending unit lead by pulling lead
toward front of connector. Disconnect leads from windshield wiper motor (41). Disconnect
capacitor connector (43).
Remove small nut (37) and large nut (39), and disconnect leads from engine wiring harness
block (38). Remove 4 nuts and 2 starwashers, and disconnect leads from glow plug relay (40).
Discard starwashers.
TA60840
4-74
