4-10. ENGINE WIRING HARNESS REPLACEMENT (Cont).

4-10. ENGINE WIRING HARNESS REPLACEMENT (Cont) - TM-9-2320-289-34_340

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
322

TM 9-2320-289-34 4-10. ENGINE WIRING HARNESS REPLACEMENT (Con’t). 1. 2. 3. 4. NOTE l Ensure that all connector are seated and locked in place as they are installed. l Ensure that engine wiring harness is secured in appropriate retainers and clamps as it is installed. Position engine wiring harness in engine compartment. Slide engine wiring harness under fuel injector lines on left and right side of cylinder head, and crankcase depression regulator valve bracket on right side. Route starter connector between rear of cylinder head next to transmission fill tube. Connect transmission downshift switch connector (54). Install clips at transmission (52) with 2 screws (53). Snap engine wiring harness to left fenderwell (47). Connect leads to current/voltage regulator (49), and install 5 new Iockwashers and nuts (50). Connect leads to current/voltage regulator relay (48), and install 5 new Iockwashers and nuts (51). Install current/voltage regulator cover with 2 screws. TA50843 4-77

Privacy Statement
Press Release
Contact