TM 9-2320-289-34
4-10.
ENGINE WIRING HARNESS REPLACEMENT (Con’t).
1 6 .
1 7.
1 8.
Remove 2 screws (53) from clips at
transmission
(52) .
Disconnect
transmission
downshift
switch
connector (54).
Unsnap all retainers and open all
clamps that hold engine wiring
harness,
Slide right side of engine wiring
harness rearward and out from below
fuel injector lines.
Pull starter
connector out from between rear of
cylinder head next to transmission fill
tube. Slide left side of engine wiring
harness from under fuel injector lines.
CAUTION
Care should be taken during removal of engine wiring harness to prevent
snagging it. Failure to follow this caution may result in damage to engine
wiring harness.
NOTE
Ensure that position of main lower engine wiring harness is noted for
installation.
19.
Remove engine wiring harness.
b
.
INSTALLATION
l
l
l
l
NOTE
if connecting all except M1010 engine wiring harness to engine
assembly, perform steps 2, 8, 12, 13, 17, and 18.
if connecting M1010 engine wiring harness to engine assembly,
perform steps 2, 8 through 11, 13, 17, and 18.
If installing ail except M1010 engine wiring harness, perform steps 1-39
6 through 8, 12, 13, and 15 through 18.
if installing M1010 engine wiring harness, perform steps 1-11 and
steps 13-18.
TA60642
4-76
