TM 9-2320-289-34
4-10.
ENGINE WIRING HARNESS REPLACEMENT (Con’t).
13.
14.
15.
16.
Install new starwasher (18) to intake
manifold stud (19). Connect engine
ground strap (17), engine wiring
harness lead (14), and terminal
board ground (15), and install nut
(16).
Connect diagnostic wiring harness
connector (12).
Connect leads to negative terminal
board center stud (8), and install new
starwasher and nut, Connect leads to
positive terminal board studs (7), and
install 2 new starwashers and nuts.
Install terminal board (9) covers.
Connect fuel filter heater connector
(10), vacuum switch connector (11),
and water sensor connector (13).
17.
Connect cold and fast idle switch connector (6), fuel solenoid connector (2), cold advance
switch connector (3), and fast idle solenoid connector (4).
18.
Connect 4 right side glow plug connectors (5),
TA60847
4-81
