TM 9-2320-289-2010-36. PERSONNEL HEATER, FUEL FILTER, AND BLOWER REPLACEMENT (M1010)(Con’t).b.INSTALLATIONNOTEIf installing blower motor (24), perform steps 1, 3 through 8, andHEATER BLEEDING steps.If installing fuel filter assembly, perform steps 2, 7, and HEATERBLEEDING steps.If installing personnel heater (1), performHEATER BLEEDING steps.Apply pipe sealant to all pipe threads beforesteps 3 through 8 andinstallation.1.Install plate (26) and blower wheel (27) on blower motor (24) with nut (28). Install blowermotor assembly by securing plate to heater base (4) with 3 screws (25). Connect lead (29) tocontrol box wire assembly (30). Connect ground lead (23).2.Fill casing (22) ¼ full of fuel oil. Install new filter element (21) in casing and new filter seal (20)on fuel filter body (2). Screw casing onto fuel filter body. Install fuel filter assembly with 2washers (19) and screws (18). Connect hose to “IN” side of fuel filter body and open shutoffvalve under truck.3.Install new exhaust gasket (17) onpersonnel heater (1). Install seal (12)on personnel heater if removed.Install personnel heater on heaterbase (4).4.Raise personnel heater (1) and installadapter (13) with new cotter pin (14),Install exhaust pipe (16) on adapterand tighten clamp (15). Installexhaust pipe hanger to exhaust pipe.TA5003310-133
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
