TM 9-2320-289-20
10-36. PERSONNEL HEATER, FUEL FILTER, AND BLOWER REPLACEMENT (M1010)
(Con’t).
c .
HEATER BLEEDING
WARNING
Diesel fuel is flammable. DO NOT perform
flames, or sparks. A fire extinguisher must
Failure to follow this warning may result in
personnel.
NOTE
this procedure near fire,
be on hand in work area.
serious injury or death to
Use suitable container to catch fuel from hose (5) and bleed port (31).
1.
Connect both battery negative cables. (See paragraph 4-38)
2.
Hold personnel heater switch in “START” position. Continue operation until a clean, steady
flow of fuel is obtained, then shut off personnel heater. Connect hose (5) to personnel heater
(1).
3.
Connect wiring
h a r n e s s ( 9 ) to
personnel heater (1).
4.
Remove personnel heater (1) cover.
Connect plastic tube to bleed port
(31). Open bleed port. Hold cab
heater switch in “START” position.
Continue operation until a clean,
steady flow of fuel is obtained, then
shut off cab heater. Close bleed port
and remove plastic tube.
5.
Install personnel heater (1) cover.
6.
Install outside access panel on right
rear ambulance body.
TA50035
10-135/(10-136 blank)
