b. ASSEMBLY - TM-9-2320-289-20

CHAPTER 11 SPECIAL PURPOSE KITS MAINTENANCE

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
612

TM 9-2320-289-20 11-1. TROOP SEAT KIT REPAIR (Con’t). 2. Remove 6 nuts (5) and bolts (6), and 3 seatback slats (7). 3. Remove screw (10) and detent pin (11) from bottom of slat (13) closest to support assembly (8). Remove 8 nuts (15), washers (14), bolts (12), and 4 slats (13). 4. Remove 2 locknuts (19), bolts (20), and 2 legs (17 or 18) from 2 troop seat frames (16). Discard locknuts. 5. Remove 2 cotter pins (21), clevis pins (22), and 2 troop seat frames (16) from support assembly (8). Discard cotter pins. 6. Remove 3 retaining pins (4) from pin holes of 2 clamps (1) and clamp (9). If damaged, remove 3 screws (2) and lanyards (3) from support assembly (8), Remove 3 retaining pins from lanyards if damaged. 7. Remove 2 clamps (1) and clamp (9) from support assembly (8) and from 3 truck stake pockets. 8. With the help of an assistant, remove support assembly (8) from truck. b. ASSEMBLY 1. 2. 3. 4. 5. 6. 7. NOTE • ASSEMBLY steps given are for one section of right side troop seat. All other sections are assembled the same way. • If installing support assembly (8) in truck, perform steps 1-4, and 10. With the help of an assistant, install support assembly (8) to top of side rail with supports in 3 truck stake pockets. Install front and middle clamps (1) in 2 stake pockets with clamps hooked over support assembly (8) and clamp plugs through holes provided in support assembly. Install rear clamp (9) in rear stake pocket with clamp hooked over support assembly (8) and clamp plug through hole in side of support assembly. Apply pressure as required to install clamp plug. If removed, install 3 lanyards (3) to support assembly (8) with 3 screws (2). If removed, install 3 retaining pins (4) to lanyards. Install retaining pins through pin holes of 2 clamps (1) and clamp (9). Install 2 troop seat frames (16) to support assembly (8) with 2 clevis pins (22) and 2 new cotter pins (21). NOTE Shorter legs (18) are installed at seats over wheel well. Install 2 legs (17 or 18) to 2 troop seat frames (16) with 2 bolts (20) and new locknuts (19). Install 4 slats (13) to 2 troop seat frames (16) with 8 bolts (12), washers (14), and nuts (15). 11-2

Privacy Statement
Press Release
Contact