10-36. PERSONNEL HEATER, FUEL FILTER, AND BLOWER REPLACEMENT (M1010)

10-36. PERSONNEL HEATER, FUEL FILTER, AND BLOWER REPLACEMENT (M1010) (Cont) - TM-9-2320-289-20_627

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
605

TM 9-2320-289-20 10-36. PERSONNEL HEATER, FUEL FILTER, AND BLOWER REPLACEMENT (M1010). This task covers: a. Removal c. Heater Bleeding b. Installation INITIAL SETUP: Equipment Condition Materials/Parts • Both battery negative cables disconnected. C o t t e r p in (See paragraph 4-38) Exhaust gasket Filter element Filter seal Fuel oil (Item 17, Appendix C) Pipe sealant (Item 43, Appendix C) Plastic tube (Item 49, Appendix C) Personnel Required General Safety Instructions • MOS 63B (2) • DO NOT perform this procedure near fire, flames, or sparks. a. REMOVAL WARNING Diesel fuel is flammable, DO NOT perform this procedure near fire, flames, or sparks. A fire extinguisher must be on hand in work area. Failure to follow this warning personnel. If removing personnel may result in serious injury or death to NOTE heater (1), perform steps 1-6. If removing fuel filter assembly, perform steps If removing blower motor, perform steps 1-6, Clean all old sealant from all pipe threads. 1, 2, and 7. and 8. 1. Remove outside access panel from right rear ambulance body. NOTE Use suitable container to catch fuel when disconnecting hose (5) and disassembling fuel filter assembly. 2. Disconnect hose (5) from personnel heater. Loosen fitting (3) and remove hose from fuel filter body (2) . 3. Loosen clamp (10) and disconnect flex hose (11) from adapter (8). Remove 4 screws (7) and adapter. 10-130

Privacy Statement
Press Release
Contact