TM 9-2320-280-34
17-13. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES (3L80) (Cont'd)
NOTE
Install six check balls only; the seventh check ball is not required.
k. Detent Solenoid
1.
Install six check balls (2) in ballseat pockets in case (1).
2.
Install two guide pins in case (1).
NOTE
Spacer plate gasket is marked "C".
3.
Install gasket (13) over guide pins.
4.
Install spacer plate (12) over guide pins.
5.
Install detent solenoid (4) on spacer plate (12) with two capscrews (5). Do not tighten capscrews (5)
at this time.
6.
Install packing retainer (16) on electrical connector (15). Align tab (14) on electrical connector (15)
with notch in side of case (1) and install electrical connector (15) into case (1).
7.
Connect detent solenoid lead (3) to electrical connector (15).
l. Front Servo
1.
Install front servo spring (11) and spring retainer (10) into front servo piston bore in case (1).
2.
Install retaining ring (8) in front servo pin (9) and install servo pin (9) in case (1) so that tapered
end of servo pin (9) contacts front band.
NOTE
The teflon ring allows the front servo piston to slide very freely in
case. The free fit of teflon ring is normal and does not indicate
leakage. The teflon ring should only be replaced if it shows
damage or evidence of leakage.
3.
Install seal ring (7) on piston (6) if removed. Install servo piston (6), with flat side of servo
piston (6) facing up, on servo pin (9).
Change 2
