TM 9-230-280-34
17-13. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES (3LB80) (Cont' )
d
i Oil Pump
1.
Install two guide pins in case (5).
2.
Coat oil sealing rings on oil pump (1) with petrolatum.
3.
Install oil pump gasket (4) over guide pins.
4.
Install oil pump (1) over guide pins and into case (5).
5.
Using wooden handle, lightly tap oil pump (1) into case (5) far enough to start capscrews (2).
6.
Remove guide pins and install five seal washers (3) and capscrews (2). Leave one threaded capscrew
hole in oil pump (1) open.
CAUTION
If turbine shaft cannot be rotated as pump is being pulled in place,
forward or direct clutch housing has not been properly installed.
This condition must be corrected before oil pump is pulled fully in
place or transmission damage will result.
7.
Evenly tighten capscrews (2) securing oil pump (1) to case (5) to 16-20 lb-ft (22-27 N m).
17-54
