TM 9-2320-280-34
15-3. 6,000 LB. ELECTRIC WINCH REPAIR (Cont'd)
d. Assembly
NOTE
For general inspection instructions, refer to para. 2-16.
1.
Install three tie rods (21) into drum support (19) with three locknuts (18).
2.
Install drive shaft (20) in brake assembly (12) and apply aircraft grease to brake assembly (12).
3.
While holding driveshaft (20), rotate brake assembly (12) to compress for installation, and install in
drum (17).
4.
Apply aircraft grease to thrust bushing (16) and install thrust bushing (16) and drum (17) on drum
support (19).
NOTE
Perform step 5 for vehicles with old configuration only.
5.
Install retaining ring (23) on spline drive (24) and install both in drum (17).
6.
Apply aircraft grease to thrust bushing (16). Install thrust bushing (16) and drum support (22) on
drum (17) and tie rods (21) with three locknuts (15). Tighten locknuts (15) and (18) to 18 lb-ft
(25 Nm).
OLD CONFIGURATION
15-11
