TM 9-2320-280-34
15-3. 6,000 LB. ELECTRIC WINCH REPAIR (Cont'd)
10.
Inspect end housing (1) for damage. Replace if damaged.
NOTE
Perform steps 11 and 12 for vehicles with old configuration only.
11.
Inspect end housing bushing (2) for damage or wear. Replace with new configuration end housing
(1) if damaged or worn. If bushing (2) is to be reused, lubricate with bushing grease.
12.
Inspect gear teeth, splines, and machined surfaces of clutch ring gear (3), stage one sun gear (4),
stage one gear carrier (5), stage two gear carrier (6), stage three gear carrier (9), ring gear (8), and
splined drive (7) for damage. Replace with new configuration parts if damaged.
NOTE
Perform step 12.1 for vehicles with new configuration only.
12.1. Inspect gear teeth, splines, and machined surfaces of clutch ring gear (3), stage one sun gear (4),
stage one gear carrier (5), stage two gear carrier (6), stage three gear carrier (9), and ring gear (8)
for damage. Replace any damaged parts.
NEW CONFIGURATION
OLD CONFIGURATION
Change 2
