TM 9-2320-289-34
6-16.
REAR AXLE DIFFERENTIAL REPAIR (Ml 009) (Con’t).
7.
Wedge 2 suitable tools between side
gear (20) and pinion shaft (10), and
camform side gear (17) and pinion
shaft. Insert telescoping gage (24)
with gage resting on gear faces, not
gear teeth.
Measure telescoping
gage with micrometer and record
reading.
8 .
Measure thickness of thrust block
(23) at outer corner and record
reading,
9 .
If thrust block (23) thickness is not
within
0.000-0.006 in.
(o.ooo-
0.152 mm)
less
than
spread
between side gear (20) and camform
side gear (17), adjust clearance by:
(a) reshimming right-hand clutch
pack, or;
(b) selecting a new thrust block (23)
of correct size to obtain required
clearance.
10.
Remove Iockscrew (9) and pinion
shaft (10).
TA50595
6-111
