b. DISASSEMBLY - TM-9-2320-289-34

6-17. REAR AXLE DRIVE PINION AND BEARINGS MAINTENANCE (ALL EXCEPT M1009)

c. CLEANING AND INSPECTION - TM-9-2320-289-34_684

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
666

TM 9-2320-289-34 6-17. REAR AXLE DRIVE PINION AND BEARINGS MAINTENANCE (ALL EXCEPT M1009) (Con’t). b. DISASSEMBLY 1 . Place retainer (1) and drive pinion (9) assembly in a soft-jawed vise. Place flange holder (8) on flange (2), and remove flange nut (3) and Iockwasher (4). Discard flange nut and Iockwasher. 2 . Thread flange remover bolt into small outside diameter end of flange remover (7). Turn flange remover 1/8 turn to a locked position. Turn flange remover while holding flange stationary and remove flange (2). If damaged, remove deflector and discard. holder (8) 3. Support retainer (1) in a press plate and press out drive pinion (9). 4 . Remove oil seal (10) from retainer (1) and discard. 5 . Remove front bearing (11) from retainer (1). Remove front and rear bearing cups (12 and 14) from retainer. 6 . Press spacer (13) and rear bearing (15) from drive pinion (9). Discard spacer. 7 . Remove straddle bearing (16) from housing (6). TA50599 6-116

Privacy Statement
Press Release
Contact