TM 9-2320-289-34
4-10.
ENGINE WIRING HARNESS REPLACEMENT (Con’t).
NOTE
Ensure that all leads are tagged for installation.
1.
Disconnect 4 right side glow plug connectors (5).
2.
Disconnect cold and fast idle switch connector (6), fuel solenoid connector (2), cold advance
switch connector (3), and fast idle solenoid connector (4).
3.
Disconnect fuel filter heater connector (10), vacuum switch connector (11), and water sensor
connector (13).
4.
Remove terminal board (9) covers. Remove 2 nuts and starwashers, and disconnect leads
from positive terminal board studs (7). Remove nut and starwasher, and disconnect leads
from negative terminal board center stud (8). Discard starwashers.
5.
Disconnect diagnostic wiring harness connector (12).
TA50836
4-70
