TM 9-2320-289-34
4-5.
STARTER TESTING AND REPAIR (Con’t).
NOTE
If field coil assembly was removed, ensure that 2 field coil assembly leads
(32) are installed with brushes (34) at insulated brush holders (31).
2.
Install grommet and field coil connector (7) in field housing (3) if removed. Connect field coil
assembly lead (32) to field coil connector with screw (33), Connect remaining field coil
assembly leads at insulated brush holders (31) and install brushes (34) with remaining screws,
3.
Assemble insulated brush holder (31) and grounded brush holder (35) on brush support (29)
with brush spring (30), Install brush support pin (28).
4.
install bushing (18) in center bearing (19) if removed. Lubricate shaft end of armature (17)
with grease. Assemble drive assembly (21), washer (20), center bearing, and armature.
5.
install collar (22) on armature (17) shaft, with cupped end facing end of shaft, Install stopring
(24) in armature shaft groove, Install thrust washer (23). Squeeze collar and thrust washer
together until collar is forced over retainer,
TA50802
6.
Install new fiber washer (27) on armature (17). install center bearing (19) and armature
assembly on drive gear housing (1) with 3 washers (25), and screws (26),
4-34
