TM 9-2320-289-34
4-5.
STARTER TESTING AND REPAIR (Con’t).
CAUTION
Dry cleaning solvent should not contact drive assembly, armature,
brushes, field coil. or nonmetallic parts. Failure to follow this caution may
result in damage to these components.
1 .
Clean drive assembly, armature, brushes, field coils, and all nonmetallic components with
clean, dry brush or cloth. Remove any loose particles with compressed air.
2.
Clean all remaining components with cloth dampened with dry cleaning solvent. Dry with
compressed air.
3.
Inspect all components for discoloration and damage. Replace any discolored or damaged
component.
NOTE
Short circuit will pull hacksaw blade (40) against armature (17) and make
hacksaw blade vibrate.
4.
Install armature (17) on growler (41).
Hold hacksaw blade (40) just above
armature
core
while
rotating
armature. if hacksaw blade vibrates,
clean between armature bars and try
again. If hacksaw blade still vibrates,
replace armature.
d.
ASSEMBLY
1.
Install alinement pin (39) if removed. install field coil assembly (38) in field housing (3). Install
4 pole shoes (37) on field coil assembly with 8 pole shoe screws (36).
TA50800
4-32
