TM 9-2320-289-34
4-6.
INSTRUMENT PANEL WIRING HARNESS AND EXTENSION REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Equipment Condition
Materials /Parts
• Instrument cluster removed,
l
Grease (Item 36, Appendix B)
(See TM 9-2320-289-20)
l
Antiseize tape (Item 65, Appendix B)
• Voltmeter relay, generator 2 relay, and starter
relay removed, (See TM 9-2320-289-20)
Manual References
• Transfer case bezel, plate, boot, and control
l TM 9-2320-289-20
lever housing removed.
(See TM 9-2320-289-20)
• Instrument panel padding removed.
(See TM 9-2320-289-20)
a.
REMOVAL
NOTE
• If removing all except M1010 instrument panel wiring harness, perform
steps 1 through 7, 9 through 12, and 14.
• If removing M1010 instrument panel wiring harness, perform
steps 1-14.
• If removing instrument panel extension wiring harness, perform steps 13
and 15.
• Voltmeter lamp connector (8), “WATER-IN-FUEL” light connector (11 ),
“WAIT” light connector (12), and instrument cluster connector (13)
were disconnected when instrument cluster was removed.
• Ensure that all leads and connectors are tagged for installation.
1.
At underside of steering column (1),
disconnect
wiper/washer
switch
connector (4) from wiper/washer
switch (3). Unplug wiper/washer
switch from bracket (2).
TA50806
4 - 3 8
Change 2
