d. INSTALLATION - TM-9-2320-289-20

10-8. DOOR AND VENT WINDOW MAINTENANCE (Cont)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
500

TM 9-2320-289-20 10-8. DOOR AND VENT WINDOW MAINTENANCE (Con’t). d. INSTALLATION NOTE If installing vent window assembly (17), perform steps 2-6. 1. 2. 3. 4. 5. Install bumper (15) if removed. Position window glass (18) and sash channel (20) assembly in door. Push window glass forward, then tilt up and slide rear window regulator assembly roller (21) into sash channel. Slide window glass backward until forward window regulator assembly roller is alined with notch in sash channel, then engage. Slide window glass assembly backward into window glass run (14) channel. Install bumper (8), retaining nut (7), and screw (9) if removed. DO NOT tighten screw. Position window glass run (14) along vent window assembly (17). Position vent window assembly in door (13), and seat edge of vent window assembly and window glass run along inside of door. Tighten screw (9), Install window regulator handle and operate window. Loosen or tighten screw as required for smooth operation, then remove window regulator handle. Install screw (16). Install screw (12). Install 2 spacers (11) and screws (10). TA49951 10-27

Privacy Statement
Press Release
Contact