TM 9-2320-289-20
10-8.
DOOR AND VENT WINDOW MAINTENANCE (Con’t).
b . D I S A S S E M B L Y
WARNING
1.
Dry cleaning
solvent P-D-680 is toxic and flammable. Always wear
protective goggles and gloves and use only in a well-ventilated area. Avoid
contact with skin, eyes, and clothes and DO NOT breathe vapors. DO NOT
use near open flame or excessive heat. The solvent’s flash point is
100°F-138°F (38°C-59°C). If you become dizzy while using cleaning
solvent, immediately get fresh air and medical help. If solvent contacts
eyes, immediately wash your eyes with water and get medical aid.
NOTE
• If disassembling door window, perform step 1.
• If disassembling vent window assembly, perform steps 2-6.
Separate window glass (18) from
sash channel (20), Apply dry cleaning
solvent to filler (19) and remove filler
from window glass.
2.
Remove pin (32) and pull off handle (22), plunger (23), and spring (24). Remove screw (31)
and stud (30). Remove washer (29), plastic washer (25), plate (27), and spacer (26) from
vent window glass (28).
CAUTION
Immediately wipe off dry cleaning solvent if it drips onto truck. Failure to
follow this caution may result in damage to truck interior or exterior paint.
3.
Open vent window and apply dry cleaning solvent to filler (44) around vent window glass (28).
When filler softens, pull vent window glass and old filler from sash (45). Discard filler.
4.
Straighten tabs on back of weatherstrip (43) and remove if damaged.
TA49948
10-24
