10-8. DOOR AND VENT WINDOW MAINTENANCE

10-8. DOOR AND VENT WINDOW MAINTENANCE (Cont)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
495

TM 9-2320-289-20 10-8. DOOR AND VENT WINDOW MAINTENANCE. This task covers: a. Removal c. Assembly b. Disassembly d. Installation INITIAL SETUP: Equipment Condition Materials/Parts Window glass lowered to full down position. Door panel removed. (See paragraph 10-7) Sharp edges of door frame covered. One rivet One vent window filler or one door window filler Adhesive (Item 2, Appendix C) Dry cleaning solvent (Item 15, Appendix C) Tape (Item 48, Appendix C) Too/s/Test Equipment General Safety Instructions • Screwdriver bit set, J-29843 • Dry cleaning solvent is flammable and must not be used near open flame. Use only in a well-ventilated area. a. REMOVAL NOTE • If replacing vent window, perform DISASSEMBLY steps 2 and 3. • If removing vent window assembly (17), perform steps 1-4. 1. Remove screw (5) and slide up cover (3). Remove bolt (4), From inside of door, remove bolt (1) and reinforcement (6). Remove spacer (2). 2. Remove 2 screws (10) and spacers (11). Remove screw (12). 3. Remove screw (16). Loosen screw (9). Peel top of window glass run (14) from door (13), Peel edge of window glass run from vent window assembly (17). Pull vent window assembly and window glass run from door, and remove vent window assembly from window glass run. 4. Remove screw (9), retaining nut (7), and bumper (8) if damaged. TA49946 10-22

Privacy Statement
Press Release
Contact