TM 9-2320-289-20
10-7.
DOOR PANEL, ARMREST, AND WINDOW REGULATOR REPLACEMENT
(Con’t).
b.
INSTALLATION
NOTE
If installing door panel (4), perform steps 3-8.
1.
Lubricate rollers (15, 17, and 18), sash channel (16), and regulator rail (19).
2.
Insert window regulator assembly (14) through access hole in door and engage rear roller (17)
in sash channel (16). Install handle (12), without retainer (11), and crank window regulator
until lower roller (18) engages on regulator rail (19). Continue cranking window regulator until
forward roller (15) engages through notch in sash channel. Aline screw holes, then remove
handle. Install window regulator assembly with 4 screws (20).
3.
Peel backing from new door panel seal (13) and install on door panel (4) if removed.
4.
Install handle plate (2) and spacer (3) on window regulator assembly (14) pin if removed.
5.
If removed, install armrest (7) on door panel (4) with nut (9).
6.
Snap door panel (4) into place on door (1), Install 6 screws (8) and 2 screws (5).
7.
Position handle plate (10) on handle (12), and install retainer (11) on notch in handle. Snap
handle assembly into place on door panel (4) and window regulator assembly (14) pin.
8.
Install grommet (6) if removed. Install door lock knob.
TA49944
10-20
