10-7. DOOR PANEL, ARMREST, AND WINDOW REGULATOR REPLACEMENT

10-7. DOOR PANEL, ARMREST, AND WINDOW REGULATOR REPLACEMENT (Cont)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
491

TM 9-2320-289-20 10-7. DOOR PANEL, ARMREST, AND WINDOW REGULATOR REPLACEMENT. This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Condition Materials/Parts • Window glass raised and taped in full up • One door panel seal position (if removing window regulator). • Grease (Item 27, Appendix C) • Duct tape (Item 47, Appendix C) Tools/Test Equipment • Retaining clip remover, J-24595-B a. REMOVAL NOTE If removing door panel (4), perform steps 1-5. 1. Remove door lock knob. Remove grommet (6) if damaged. 2. Remove handle (1 2), retainer (11), and handle plate (10). 3. Remove 2 screws (5) and 6 screws (8). Pry door panel (4) away from door (1) and remove. Remove spacer (3) and handle plate (2) from window regulator assembly (14) pin as required. Perform step replaced. NOTE 4 only if armrest (7) is damaged or door panel (4) is being 4. Remove nut (9) and armrest (7) if required. 5. Inspect door panel seal (13) for damage, and replace if required. Clean all seal material from door panel (4) if removed. 6. Remove 4 screws (20). install handle (12), without retainer (11), on window regulator assembly (14). Crank window regulator to disengage front roller (15) from sash channel (16). While holding front roller clear of sash channel, crank window regulator in opposite direction to disengage lower roller (18) from regulator rail (19), Remove handle and move window regulator assembly rearward to disengage rear roller (17) from sash channel. Remove window regulator assembly through access hole in door. 10-18

Privacy Statement
Press Release
Contact