b. INSTALLATION - TM-9-2320-289-20

4-29. TAILLIGHT AND LAMP REPLACEMENT (M1010 AND M1031) (Cont)

4-30. REAR BLACKOUT LIGHT REPLACEMENT (ALL EXCEPT M1010 AND M1031)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
283

TM 9-2320-289-20 4-29. TAILLIGHT AND LAMP REPLACEMENT (M1010 AND M1031) (Con’t). b. INSTALLATION 1. 2. 3. NOTE If installing taillight housing (8), perform steps 2-6. Install both lamps (11 and 12) in step 5. If installing taillight lamps (11 or 12), perform steps 5 and 6. If installing taillight lens (9), perform step 6. Install taillight mounting bracket (7) on frame rail (3) with 2 new Iockwashers (2), screws (1), and nuts (4). Plug wiring harness leads into wiring harness connector and install taillight housing (8) on taillight mounting bracket (7) with new Iockwasher (6) and nut (5). Install plastic ties as required. NOTE On 1984 model trucks, blackout light mounting bracket (13) is not attached to taillight mounting bracket (7). Position blackout light mounting bracket (13) on taillight housing (8) studs. NOTE On 1984 model trucks, ground (14) is connected to blackout light mounting bolt. 4. 5. 6. Install Install Install ground (14), 2 new Iockwashers (15), and nuts (16). stoplight lamp (12) and back-up light lamp (11) as required. taillight lens (9) gasket and taillight lens with 4 screws (10). FOLLOW-ON TASKS: Connect both battery negative cables. (See paragraph 4-38) Check operation of taillight. 4-59

Privacy Statement
Press Release
Contact