TM 9-2320-289-20
4-30.
REAR BLACKOUT LIGHT REPLACEMENT (ALL EXCEPT M1010 AND M1031).
This task covers:
a.
Removal
b. Installation
INITIAL SETUP:
Equipment Condition
Materials/Parts
Both battery negative cables disconnected.
Plastic ties (as required)
(See paragraph 4-38)
NOTE
If removing rear blackout light (6) only, perform steps 1-3.
1.
Remove plastic tie if installed.
Disconnect rear blackout light (6)
plug from wiring harness plug (3).
2.
Remove nut (1) and ground (4).
3.
Remove 2 nuts (9) and rear blackout
light (6).
4.
Remove nut (2), screw (8), and
mounting bracket (5).
b.
INSTALLATION
1.
Install mounting bracket (5) on rear
bumper (7) with screw (8) and nut
(2) .
2.
Install rear blackout light (6) on
mounting bracket (5) with 2 nuts (9).
3.
Install ground (4) with nut (1).
4.
Connect rear blackout light (6) plug
to wiring harness plug (3). Install
plastic tie as required.
FOLLOW-ON TASKS:
Connect both battery negative cables. (See paragraph 4-38)
Check operation of rear blackout light.
TA49895
4-60
