TM 9-2320-280-34
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Equipment Conditions
General mechanic's tool kit:
Engine right splash shield removed
automotive (Appendix G, Item 1)
(TM 9-2320-280-20).
Materials/Parts
General Safety Instructions
Two cotter pins (Appendix E, Item 166)
Do not touch hot exhaust system with
bare hands.
Manual References
Maintenance Level
TM 9-2320-280-20
Direct support
TM 9-2320-280-24P
WARNING
Do not touch hot exhaust system components with bare hands.
Severe injury will result.
a. Removal
1.
Remove cotter pin (2) and exhaust pipe elbow (1) from exhaust diverter box (8). Discard cotter pin (2).
2.
Loosen clamp (5) securing insulator sleeve (4) to flex tube (7).
3.
Slide insulator sleeve (4) above cotter pin (6) and remove cotter pin (6) and exhaust pipe elbow (1) from
flex tube (7). Discard cotter pin (6).
4.
Remove clamps (3) and (5) and insulator sleeve (4) from exhaust pipe elbow (1).
b. Installation
1.
Install insulator sleeve (4) and clamps (3) and (5) on exhaust pipe elbow (1) and secure with clamp (3).
2.
Install exhaust pipe elbow (1) on exhaust diverter box (8) with cotter pin (2).
3.
Connect exhaust pipe elbow (1) on flex tube (7) with cotter pin (6).
4.
Slide insulator sleeve (4) down over cotter pin (6) on flex tube (7) with clamp (5).
FOLLOW-ON TASK: Install engine right splash shield (TM 9-2320-280-20).
16-7
