TM 9-2320-280-34
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Equipment Condition
General mechanic's tool kit:
Engine right splash shield removed
automotive (Appendix G, Item 1)
(TM 9-2320-280-20).
Arctic heater exhaust pipe removed
Materials/Parts
Two cotter pins (Appendix E, Item 166)
Arctic heater elbow to exhaust diverter
Three lockwashers (Appendix E, Item 120)
elbow removed (para. 16-6).
Manual References
General Safety Instructions
TM 9-2320-280-20
Do not touch hot exhaust system with
TM 9-2320-280-24P
bare hands.
Maintenance Level
Direct support
WARNING
Do not touch hot exhaust system components with bare hands.
Severe injury will result.
a. Removal
1.
Remove capscrew (6), lockwasher (7), and exhaust control cable bracket (5) from exhaust diverter
box (3). Discard lockwasher (7).
2.
Remove cotter pin (1), washer (2), and exhaust control cable (8) from exhaust diverter lever (4).
Discard cotter pin (1).
3.
Remove cotter pin (9) and exhaust pipe elbow (10) from exhaust diverter box (3). Discard cotter
pin (9).
4.
Remove two capscrews (13), lockwashers (12), and exhaust diverter box (3) from body flange (11).
Discard lockwashers (12).
b. Installation
1.
Install exhaust diverter box (3) on body flange (11) with two lockwashers (12) and capscrews (13).
2.
Connect exhaust pipe elbow (10) on exhaust diverter box (3) with cotter pin (9).
3.
Install exhaust control cable (8) on exhaust diverter lever (4) with washer (2) and cotter pin (1).
4.
Install exhaust control cable bracket (5) on exhaust diverter box (3) with lockwasher (7) and
capscrew (6).
Change 2
