TM 9-2320-280-34
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Equipment Conditions
General mechanic's tool kit:
Engine right splash shield removed
automotive (Appendix G, Item 1)
(TM 9-2320-280-20).
Materials/Parts
General Safety Instructions
Two cotter pins (Appendix E, Item 166)
Do not touch hot exhaust system with
Locknut (Appendix E, Item 77)
bare hands.
Manual References
Maintenance Level
TM 9-2320-280-20
Direct Support
TM 9-2320-280-24P
WARNING
Do not touch hot exhaust system components with bare hands.
Severe injury will result.
a. Removal
1.
Loosen clamp (3) securing insulator sleeve (1) to flex tube (5).
2.
Slide insulator sleeve (1) above cotter pin (4) and remove cotter pin (4) and flex tube (5) from
exhaust pipe elbow (2). Discard cotter pin (4).
3.
Remove locknut (11), capscrew (7), clamp (8), and flex tube (5) from strap (6). Discard locknut (11).
4.
Remove cotter pin (10) and flex tube (5) from oil pan shroud (9). Discard cotter pin (10).
b. Installation
1.
Install flex tube (5) on oil pan shroud (9) with cotter pin (10).
2.
Connect flex tube (5) to exhaust pipe elbow (2) with cotter pin (4).
3.
Install flex tube (5) on strap (6) with clamp (8), capscrew (7), and locknut (11).
4.
Slide insulator sleeve (1) down over cotter pin (4) with clamp (3).
FOLLOW-ON TASKS: Install engine right splash shield (TM 9-2320-280-20).
Change 2
