TM 9-2320-280-34
7-8. TRANSMISSION/TRANSFER CASE ASSEMBLY REMOVAL (4L80-E) (Cont'd)
NOTE
It will be necessary to rotate flywheel clockwise from capscrew in
front of crankshaft to gain access to capscrews securing torque
converter.
10.
converter (27) away from flywheel (25).
CAUTION
Safety chain must be routed under transmission oil cooler lines and
speedometer cable or damage may result.
11.
Support transmission (19) with transmission jack and secure with safety chain.
12.
Remove two capscrews (13) from transmission adapter (6) and bracket (11).
13.
Remove locknut (12), two washers (9), bypass valve (7), and capscrew (8) from right side of
crossmember (14) and support bracket (10). Discard locknut (12).
14.
Remove locknut (15), washer (16), crossmember (14), and two washers (4), stud (2), cable (5), and
two nuts (3) from support bracket (1). Discard locknut (15).
CAUTION
If transmission is lowered too far, cooling fan damage will
result.
Wood block must completely cover bottom of engine oil pan or
oil pan damage will result.
15.
Lower transmission (19) slightly and support engine under oil pan (24) with wood block and stand.
16.
Disconnect main vent line (20) from transmission/transfer case vent line (21).
17.
Remove 90 degree speedometer adapter (32) from transfer case (22) and disconnect speedometer
cable (31) from bracket (28). Secure 90 degree speedometer adapter (32) and speedometer cable (31)
away from transfer case (22).
18.
Disconnect two leads (34) from transfer case switch leads (33) on transfer case (22).
19.
Remove four tiedown straps (30) and harness (29) from speedometer cable (31).
Discard tiedown straps (30).
20.
Remove four capscrews (23) and two studs (18) from transmission (19) and engine (17).
Change 2
