TM 9-2320-280-34
7-9. TRANSMISSION/TRANSFER CASE ASSEMBLY INSTALLATION (4L80-E) (Cont'd)
NOTE
Bracket nuts must be loosened prior to installation of crossmember
on vehicle for proper alignment.
6.
Loosen two nuts (22) on bracket (20) and crossmember (24).
7.
Install bracket (20) and crossmember (24) on transmission adapter (15) with two capscrews (23).
Tighten capscrews (23) to 65 lb-ft (88 Nm).
8.
Install two nuts (12), washers (13), cable (14), washer (26), and locknut (25) on crossmember (24)
and support bracket (10). Tighten locknut (25) to 90 lb-ft (122 Nm).
9.
Install capscrew (17), two washers (18), bypass valve (16), and locknut (21) on crossmember (24) and
support bracket (19). Tighten locknut (21) to 65 lb-ft (88 Nm).
Tighten two nuts (22) to 65 lb-ft (88 Nm).
10.
Change 2
7-23
