TM 9-2320-280-34
3-26. ENGINE PREPARATION (6.2 L AND 6.5 L) (Cont'd)
NOTE
Perform steps 31 through 34 for 6.2 L engines only.
Replace power steering drivebelts in matched sets only.
31.
Feed belt set (14) into inner grooves on crankshaft pulley (12), water pump pulley (13), and power
steering pump pulley (11).
32.
Install adjusting capscrew (16) through adjusting slot in alternator support bracket (19). Do not
tighten capscrew (16).
CAUTION
Do not pry against power steering pump housing with pry bar
when adjusting belt tension. Damage to equipment may result.
NOTE
New belt tension should read 105 + 5 lbs (476 + 22 N).
Used belt tension should read 90 + 5 lbs (400 + 22 N).
33.
Using belt tension gauge, check each belt for proper tension.
34.
Tighten two capscrews (15) and adjusting capscrew (16) to 40 lb-ft (54 Nm) on power steering
pump bracket (20), alternator bracket (19), and power steering pump (10).
35.
Position wiring harness (25) in approximate mounting location.
36.
Install wiring harness (25) on bracket (26) with capscrew (27), clamp (28), and nut (29).
37.
Install wiring harness (25) on cylinder block (21) with clamp (22), lockwasher (23), and nut (24).
10
15
22
21
23
11
16
20 19
24
10
25
26
29
27
13
28
12
11
14
3-197
