TM 9-2320-280-34
3-26. ENGINE PREPARATION (6.2 L AND 6.5 L) (Cont' )
d
WARNING
Alternator must be supported during installation. Failure to
support alternator may cause injury to personnel or damage to
equipment.
NOTE
Perform steps 25 through 29 for vehicles equipped with 60 and
100 amp Prestolite alternator only.
In some cases, a thru-bolt and nut may be present on mounting
bracket instead of standard capscrews and washers.
25.
Install alternator (20) on mounting bracket (5) with support bracket (19) between mounting
bracket and alternator (20) with two washers (18), lockwashers (17), and capscrews (16).
26.
Align alternator (20), and adjusting bracket (12), and install washer (13), lockwasher (14), and
capscrew (15).
NOTE
Perform steps 27 through 29 for vehicles with new alternator
support bracket configuration.
27.
Position alternator (21) on mounting bracket (28) with support bracket (27) on the outside of
alternator (21) mounting flange.
28.
Position spacer (26) between alternator (21) and mounting bracket (28).
29.
Install alternator (21) and power steering lines bracket (25) on support bracket (21) and mounting
bracket (28) with two washers (24), lockwashers (23), and capscrews(22).
3-195
