TM 9-2320-280-34
3-25. ENGINE INSTALLATION (6.5 L) (Cont'd)
NOTE
Perform steps 87 through 101 for vehicles equipped with Neihoff
200 amp alternator only.
Ensure terminals are clean before connections are made.
87.
Position alternator (13) on mounting bracket (37) with support bracket (48) and power steering lines
bracket (47) on outside of alternator mounting flange (49) and install spacer (50), washer (45), thru-
bolt (46), washer (45), lockwasher (51), and nut (44).
88.
Deleted
89.
Deleted
90.
Install insulator washer (43) in fuse link (30).
91.
Install washer (32), positive cable (31), fuse link (30), and insulator washer (43) on positive stud (33)
with washer (29), lockwasher (28), and nut (27). Tighten nut (27) to 10-15 lb-ft (14-20 Nm).
92.
Install lead 3B (38) to negative stud (36) with washer (39), lockwasher (40), and nut (41). Tighten
nut (41) to 8-12 lb-ft (11-16 Nm).
93.
Position 3/8-inch breaker bar on belt tensioner (52), move tensioner (52) clockwise and install
drivebelt (34) on pulley (35). Release belt tensioner (52).
94.
Install rubber boot (42) over stud (33).
95.
Apply sealing compound to threads of capscrew (6).
96.
Install spacer (10) and voltage regulator (8) on alternator (13) with lockwasher (7) and capscrew (6).
Tighten capscrew (6) to 88-94 lb-in. (10-11 Nm).
97.
Install two washers (14), spring tension washers (15), and screws (16) connecting voltage regulator
(8) to alternator (13). Tighten screws (16) to 30-34 lb-in. (3-4 Nm)
98.
Install washer (20), lead (17), and nut (19) on terminal (21). Tighten nut (19) to 18-22 lb-in.
(2.0-2.5 Nm). Slide rubber boot (18) over terminal (21).
99.
Install washer (23), lead 5A (24), and nut (25) on red (energize) terminal (22). Tighten nut (25) to
23-27 lb-in. (2.6-3.0 Nm). Slide rubber boot (26) over terminal (22).
100.
Install washer (4), lead 2A (3), and nut (2) on yellow (AC) terminal (5). Tighten nut (2) to 18-22 lb-in.
(2.0-2.5 Nm). Slide rubber boot (1) over terminal (5).
101.
Connect regulator plug (9) to voltage regulator (8).
102.
Connect lead (12) to connector (11).
Change 2
