TM 9-2320-266-34
(2) If complete control box assembly is being re-
placed (para. a(5) above), remove two screws and slide out
panel with attached parts from case.
(3) Place two screws with washers through case
holes. Position one washer each on screw ends and position
screws through mounting bracket holes of base plate. In-
stall nut on screw end ON-OFF switch. On other screw
position lockwasher, power harness terminal lug, heater
harness terminal lug, and split Iockwasher, and retain all
with nut.
(4) With electrical components assembled as a unit,
slide panel into case and secure with two screws.
(5) Connect electrical connector of power harness
and connector of heater harness to control box assembly.
(6) Install guard and retain with three screws and
nut.
(7) Connect 24 volt battery ground cable.
24-24. Radiator Grille Cover.
Refer to TM 10-269 for general repair instructions.
24-25. Engine Hood Cover.
Refer to TM 10-269 for generaI repair instmctions.
24-26. Cargo Box Cover.
Refer to TM 10-269 for general repair instructions.
24-27. Cargo Box Bow.
a. Removal
(1) Disconnect personnel heater duct by removing
top clamp on duct.
(2) Remove cargo cover attaching hardware.
(3) Fold cargo cover from frame to expose bows.
(4) Replace defective components of bow assembly
as required.
b. Installation.
(1) Place cargo cover in position and secure with
attaching hardware.
(2) Connect personnel heater duct and secure with
clamp.
24-16
Change 5
