TM 9-2320-289-34F-1 .GAS-PARTICULATE FILTER UNIT (GPFU) INSTALLATION (M1010) (Con’t).10.Install 2 small plastic orifices (18), with pipe sealant, into threaded ends of each adapter (1) attop and side outlets (11) of patient heater (12). Install threaded plastic plug to top inlet (13) ofheater.11.Install patient heater (12), with inlet side (14) facing toward outside of truck, to top of heaterbracket located on front driver’s side of litter support. Secure heater with 4 bolts, washers,and nuts,12.Install end of 2 ft. (0,61 m) flex hose (15) to inlet (14) side of patient heater (12) with hoseclamp.13.Install 2 brass adapters (1) to cab tee(9) .14.Install cab tee (9) on top front wall atleft side of air conditioner with sideopening to bottom. Secure with teeclamp (5), screws, and Iockwashers.15.Connect end of 2 ft. (0.61 m) flexhose (7) to left end of cab tee (9)with hose clamp. Run flex hose upand along top of gas-particulate filterunit (6).TA50184F-4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business