Section Il. ILLUSTRATED MANUFACTURING INSTRUCTIONS - Continued

Section Il. ILLUSTRATED MANUFACTURING INSTRUCTIONS - Continued - TM-9-2320-289-34_937

Section Il. ILLUSTRATED MANUFACTURING INSTRUCTIONS - Continued.

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
920

TM 9-2320-289-34 Section Il. ILLUSTRATED MANUFACTURING INSTRUCTIONS- 1 . 2. 3. 4. 5 . 6. 7. 1 . 2. 3. 4. 5. 6. 7 . C o n t i n u ed Fabricate from steel tubing, 1/4 in. outside diameter, stock size 25 ft. long, NSN 4710-01-161-0138. Cut to 91.51 in. long for Part Number 14034586. Cut to 90.52 in. long for Part Number 15522444. Install nut, NSN 4730-01-154-1366, Part Number 9424955, on one end of tubing. Install nut, NSN 4730-00-014-2432, Part Number 137397 on other end of tubing. Flare ends of tubing. Nuts should turn freely on flares. NOTE Ensure that nuts are correctly positioned before bending tubing. Use old pipe as a guide and bend steel tubing to same shape. Figure C-14. Rear Combination Valve Pipe Fabricate from steel tubing, 3/18 in. outside diameter, stock size 25 ft. long, NSN 2530-00-395-5144. Cut to 29.43 in. long for Part Number 14034571, Cut to 42.13 in. long for Part Number 14034572. Cut to 30.44 in. long for Part Number 14054275. Install nut, NSN 4730-00-288-9390, Part Number 9432075, on each end of tubing. Flare ends of tubing. Nuts should turn freely on flares. Use old pipe as a guide and bend steel tubing to same shape. Figure C-15. Caliper Pipe C -8

Privacy Statement
Press Release
Contact