Section Il. ILLUSTRATED MANUFACTURING INSTRUCTIONS - Continued

Section Il. ILLUSTRATED MANUFACTURING INSTRUCTIONS - Continued - TM-9-2320-289-34_936

Section Il. ILLUSTRATED MANUFACTURING INSTRUCTIONS - Continued - TM-9-2320-289-34_938

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
919

TM 9-2320-289-34 Section Il. ILLUSTRATED MANUFACTURING INSTRUCTIONS- 1. 2. 3. 1. 2. 3. 4. 5. 6. 7. 1. 2. 3. 4. 5. 6. C o n t i n u ed Fabricate from steel tubing, 1/8 in. outside diameter, stock size 25 ft. long, NSN 4710-01-192-1433. Cut to 23.82 in, long for Part Number 14029235. Use old pipe as a guide and bend steel tubing to same shape, Figure C-11. Front Axle Vent Pipe Fabricate from steel tubing, 1/4 in, outside diameter, stock size 25 ft. long, NSN 4710-01-161-0138, Cut to 78.49 in. long for Part Number 15599260, Cut to 75.25 in. long for Part Number 15599262, Install nut, NSN 4730-01-154-1366, Part Number 9424955, on one end of tubing. Install nut, NSN 4730-00-014-2432, Part Number 137397 on other end of tubing, Flare ends of tubing. Nuts should turn freely on flares. NOTE Ensure that nuts are correctly positioned before bending tubing, Use old pipe as a guide and bend steel tubing to same shape. Figure C-12. Rear Master Cylinder Pipe Fabricate from steel tubing, 3/16 in. outside diameter, stock size 25 ft. long, NSN 2530-00-395-5144. Cut to 72.68 in. long for Part Number 15599259. Cut to 76.63 in. long for Part Number 15599261. Install nut, NSN 5310-00-380-1514, Part Number 9424954, on each end of tubing, Flare ends of tubing. Nuts should turn freely on fIares. Use old pipe as a guide and bend steel tubing to same shape. Figure C-13. Front Master Cylinder Pipe C - 7

Privacy Statement
Press Release
Contact