TM 9-2320-289-34APPENDIX DTORQUE LIMITSD-1.SCOPE.This appendix lists standard torque values, as shown in Table D-1, and provides generalinformation for applying torque.Special torque values and sequences are indicated in themaintenance procedures for applicable components.D-2.GENERAL.a. Always use the torque values listed below when the maintenance procedure does notgive a specific torque value.b. Unless otherwise specified, standard torque tolerance shall be ±10%.c. Torque values listed are based on clean and dry threads. Reduce torque by 10%. whenengine oil is used as a lubricant.Table D-1. Standard Torque SpecificationsNUT OR BOLT SIZETORQUENUT OR BOLT SIZETORQUE(inch)GRADE SGRADE 8(millimeter)GRADE 9.8GRADE 10.9FINE & COARSE THREADSIb. -ft.N.mIb.-ft.NomIb. -ft.N-mIb. -ft.N.m1 /46810146101412165/16152021298202723313/826353750104054486571164358608112709580109112658890122141131531321799/1690122130176161762392072815/8130176178241203434653995413141852512603537/83004084205701440597635861D-1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business