TM 9-2320-289-34
6-20.
REAR SPRING ASSEMBLY AND BUSHINGS REPLACEMENT (Con’t).
9.1.
9 . 2
9 . 3
NOTE
. Perform step 9,1 for M1028A2 and M1028A3.
. Adapters (7,1) are mismarked on casting as to left-hand and right-hand.
Install adapters as shown, with ribs up and curved arm to rear facing
inboard,
If removed, install shim (4) on axle (5)
housing with thinner edge facing front.
Raise axle, alining spring assembly (1)
center bolt hole with hole in shim and
axle housing. Install spacer (2). Install
anchor plate (8) and 2 “ U“ bolts (3)
with 4 washers (7.2), adapter (7.1), 4
washers (6), and nuts (7). Install all
nuts to uniform engagement on “U“
bolts to retain and position anchor
plate and adapter.
Check axle to see that spring dowel
pins are through angle shim and are
seated in axle.
Check that “U” bolts are properly
positioned in upper spacer grooves.
6-140
Change 2
