TM 9-2320-289-34
5-17.
TRANSMISSION DIRECT CLUTCH ASSEMBLY AND FRONT BAND
MAINTENANCE.
This task covers:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Cleaning and Inspection
INITIAL SETUP:
Equipment Condition
Materials/Parts
l Forward clutch assembly removed.
• One direct clutch housing seal
(See paragraph 5-1 6)
l Two direct clutch piston seals
l Dry cleaning solvent
(Item 23, Appendix B)
l Hydraulic fluid (Item 40, Appendix B)
l Petrolatum (Item 50, Appendix B)
Tools/Test Equipment
General Safety Instructions
• Clutch rebuilder, J-23327
• Dry cleaning solvent is flammable and
l Inner seal protector, J-21362
must not be used near open flame.
l protector seal, J-21409
Use only in a well-ventilated area.
l Snapring pliers
• Compressed air used for cleaning
purposes should never exceed 30 psi
(207 kPa).
a.
REMOVAL
1.
Remove direct clutch assembly (3)
from transmission case (1).
2.
Remove front band (2).
TA50273
5-92
