TM 9-2320-289-34
5-17.
TRANSMISSION DIRECT CLUTCH ASSEMBLY AND FRONT BAND
MAINTENANCE (Con’t).
3.
Place inner seal protector (22) over
direct clutch assembly (3) hub, Install
direct clutch piston (17) inside outer
Seal
protector
(21
)
and
insert
assembly in direct clutch assembly
housing. Rotate direct clutch piston in
a
clockwise direction
until fully
seated, Remove inner and outer seal
protectors.
NOTE
2 empty spring guides (23) should
be diagonally opposite each other.
4.
Install 14 piston release springs (15)
into spring guides (23) in direct clutch
piston (1 7).
5 .
Place piston spring retainer (14) over
piston release springs (15), Using
clutch rebuilder,
compress piston
spring retainer, being careful to not
catch piston
spring
retainer
in
snapring groove.
Install snapring
(1 6), Remove clutch rebuilder.
6 .
If any piston release spring (15) is
leaning,
straighten
with
a
small
screwdriver.
TA50278
5-97
